Universal treadmill board and console kit – suitable for any DC treadmill motor
Special Price
€289.99
Regular Price
€400.00
In stock
SKU
kit-scheda-motore-e-console-tapis-2
Universal treadmill controller and console kit, suitable for 180-230V DC motors.
Special notes: for treadmills with manual inclination and for treadmills with inclination without encoder, contact us. See in the video below how the universal replacement kit works.
Special notes: for treadmills with manual inclination and for treadmills with inclination without encoder, contact us. See in the video below how the universal replacement kit works.
This kit is made up of:
console with backlight LCD, generous size
powerful control board that can drive DC motors of any size
security key
magnetic sensor kit + magnet to be placed on the treadmill roller to read the speed
Console Features
Security key
Provides reading of BMI (body index) and body fat
Gradient control: 12 levels inclination motor
Programs: manual, 8 pre-set programs, objectives, HRC and 2 user settings
Simple speed control, inclination and start / stop
Predisposition for heartbeat control (via handpulse or chest belt by means of a special adapter)
Installation
Pass the wiring of the new kit, by drilling a small hole in the original console plastic
Remove the original treadmill's motor controller, including any connected transformers, which will no longer be needed
Place the new control board in place of the old one, and then reconnect the cables as instructed.
Speed sensor 2 PIN connector
if the old board did not have speed sensor -> install the 2 pin sensor provided in the kit on the roller
if the old board had a 3 or 4 pin sensor - remove the old sensor and install the 2 pin sensor supplied in the kit on the roller
Inclination sensor: 3 PIN connector
Console data cable: 4 PIN connector
Main motor cables: two Faston connectors, M + (red) and M- (black)
Inclination Motor Cables: Three Faston Connectors, White COM - Red UP - Black DOWN
AC power cables (place on AC connectors).
Connect the console data cables, in particular, the controller-console data cable and any other connectors (handpulse, additional keyboards), as shown in the enclosed scheme.
Now paste the new console, using the two-sided tape supplied with the kit.
console with backlight LCD, generous size
powerful control board that can drive DC motors of any size
security key
magnetic sensor kit + magnet to be placed on the treadmill roller to read the speed
Console Features
Security key
Provides reading of BMI (body index) and body fat
Gradient control: 12 levels inclination motor
Programs: manual, 8 pre-set programs, objectives, HRC and 2 user settings
Simple speed control, inclination and start / stop
Predisposition for heartbeat control (via handpulse or chest belt by means of a special adapter)
Installation
Pass the wiring of the new kit, by drilling a small hole in the original console plastic
Remove the original treadmill's motor controller, including any connected transformers, which will no longer be needed
Place the new control board in place of the old one, and then reconnect the cables as instructed.
Speed sensor 2 PIN connector
if the old board did not have speed sensor -> install the 2 pin sensor provided in the kit on the roller
if the old board had a 3 or 4 pin sensor - remove the old sensor and install the 2 pin sensor supplied in the kit on the roller
Inclination sensor: 3 PIN connector
Console data cable: 4 PIN connector
Main motor cables: two Faston connectors, M + (red) and M- (black)
Inclination Motor Cables: Three Faston Connectors, White COM - Red UP - Black DOWN
AC power cables (place on AC connectors).
Connect the console data cables, in particular, the controller-console data cable and any other connectors (handpulse, additional keyboards), as shown in the enclosed scheme.
Now paste the new console, using the two-sided tape supplied with the kit.